3M C1060 Owner's Manual download pdf (Page 19)

Model C1060 Maintenance

 3M 2001 February

When the battery voltage is too low, the headset sounds a short, low–volume

tone at seven–second intervals to alert the operator to install a fully charged

battery. The “low battery tone” continues for two minutes after which the

headset turns off automatically to prevent damage to the batteries.

ü Note

When installing a battery, make sure it is fully charged. It is important to

remember that an unused C1060 battery loses five percent of its charge per

week. If a battery has not been used for several weeks, make sure to charge

prior to use.

To replace the battery:

1. Slide and hold the battery release. See Figure 11.

2. Remove the discharged battery from the battery housing.

Insert a fully charged battery in the housing with the notch facing the

battery release. Make sure the battery is fully inserted (battery release

clicks). See Figure 11.

Figure 11.

Headset

Replacing the Battery

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 33 34

No comments

3M C1060 Owner's Manual Page 19