3M 1465DWIT Datasheet download pdf (Page 2)

Warnings

• Do NOT apply paint, solvents, adhesives or self adhesive

labels on to the helmet.

• Use ONLY rubber or acrylic based adhesives to stick

anything to the helmet.

• To provide proper protection against potential head injuries

ensure the 3M 1465 helmet is:

* Suitable for the job

* Fitted properly on the head

* Worn all the time in designated hard hat areas

* Replaced when necessary

• Before wearing the helmet check to ensure there are no signs

of cracks or other defects.

• If in doubt contact your Safety Officer or 3M for further

advice.

Printed in Belgium 10/95

1465 Helmet

Fitting & Adjustment

- Adjust the headband nap strap to alter the headband width to

achieve a comfortable, secure fit.

The height of the head harness is adjusted by attaching the

headband to either pin A or B (Diagram 1).

Using pin A will position the helmet deeper on the head.

Using pin B will position the helmet higher on the head.

Pin A or B can be selected in each of the 4 points to attain

optimum fit.

Occupational Health Group

3M United Kingdom PLC

3M House, PO Box 1,

Market Place, Bracknell,

Berkshire RG12 1JU

Tel: Bracknell (01344) 858000

Occupational Health Group

3M Ireland

3M House, Adelphi Centre, Upper Georges St.

Dun Laoghaire

Co. Dublin, Ireland

Tel : 01 2803555

Diagram 1

1 2

No comments

3M 1465DWIT Datasheet Page 2