3M™ Multi-Touch Chassis Display User Guide 11
3M Touch Systems, Inc. Proprietary Information – TSD-37732F
CHAPTER 2
Setting up Your Multi-Touch Chassis Display
This chapter describes how to set up your 3M Touch Systems Multi-Touch Chassis
Display. You need to complete the following tasks:
• Unpack the components
• Connect the video, touch display cables, and power cable
• Power on the display and test your setup
• If you are not running Windows 7 (or Tablet PC), install MT7 software from the
enclosed CD. Note that this will not make multi-touch happen -- it is up to your
application to enable multi-touch.
System Requirements
The Multi-Touch Chassis Display requires a personal computer (PC). The requirements
for your PC are as follows:
• Your PC must have an available USB or RS-232 serial communication (COM) port.
You connect the touch sensor cable to this communications port.
• Your PC must have a video card and video driver already installed for the display. If
you need to install a video card or a video driver, refer to your computer
documentation for instructions.
Note: Before setting up your Multi-Touch Chassis Display, refer to the “Important
Safety Information” section at the beginning of this document.
Unpacking Your Touch Display
Carefully unpack the carton and inspect the contents. Your Multi-Touch Chassis Display
includes the following cables and accessories:
• USB and RS-232 serial communication cables
• DVI and VGA video cables
Comments to this Manuals