3M C2254PW User's Guide download pdf (Page 8)

8 3M™ Multi-Touch Chassis Display User Guide

3M Touch Systems, Inc. Proprietary Information – TSD-37732F

CAUTION

To avoid the potentially hazardous situations associated with the use of alcohol or

other solvents which may result in minor or moderate injury or property damage:

• Follow all instructions and recommendations in the manufacturer's Material Safety

Data Sheet and product label.

• Be sure to follow solvent manufacturer's precautions and directions for use when using

any solvents

• It is important to avoid using any caustic chemicals on the touch sensor.

To avoid possible environmental contamination which may result in minor or

moderate injury:

• The lamp(s) inside this product contain mercury (Hg) and must be recycled or

disposed of in accordance with local, state, or federal laws. Check your individual

state's requirements to see if specific recycling requirements exist for mercury-

containing products or other electronic products. Refer to

http://www.nema.org/lamprecycle/

or call 3M Touch Systems 1-866-407-6666 for

further information.

•

Dispose of the flat panel display according to applicable governmental regulations

Important Notes

• In extreme temperature and humidity situations, you may observe condensation

between the touch screen and the display. To minimize this condition, place the unit

where it will be used and allow a 24-hour environmental stabilization period prior to

powering on the display. Any noticeable condensation is temporary and will have no

long term affect on the operation of the display.

• You are cautioned that any change or modification to the equipment not expressly

approved by the party responsible for compliance could void your authority to

operate such equipment.

• When unplugging the power supply cord, hold the plug, do not pull by the cord.

• Do not connect or disconnect this product during an electrical storm.

• Remember to take into account that the operating temperature of the installation may

be greater than the room ambient, and consideration should be given to installing the

unit in an environment compatible with the maximum rated operating temperature.

Specifications can be found in the product data sheet on the 3M Touch Systems

website at http://www.3m.com/touch/

• When installing the unit, ensure that it does not restrict the flow of air to any other

equipment within the installation required for safe operation.

• An inherent characteristic of the PCT sensor is a fine grid pattern that may be visible

under certain lighting conditions.

• Install the display in a well-ventilated area. Always maintain adequate ventilation to

protect the display from overheating and to ensure reliable and continued operation.

• Do not expose this display to direct sunlight or heat. Passive heat may cause damage

to the housing and other parts.

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 29 30

Comments to this Manuals

No comments

3M C2254PW User's Guide Page 8

Comments to this Manuals

Related products and manuals for Touch screen monitors 3M C2254PW