3M M1700SS Specifications download pdf (Page 30)

3M™ MicroTouch™ Display M1700SS User Guide 30

Document #19-268 Rev AL

• Always dampen the cloth and then clean the sensor. Be sure to spray the cleaning

liquid onto the cloth, not the sensor, so that drips do not seep inside the display or

stain the bezel.

• Always handle the touch sensor with care. Do not pull on or stress cables.

Monitor Installation Problems

Problem Possible Causes and Solutions

o image

displayed (blank

screen)

Is the display receiving power?

• Check that the computer’s power cable is connected properly and securely in a

grounded electrical outlet.

• Check that the AC/DC power supply is firmly plugged into the display.

• Check that the green light appears on the bezel indicating the display is

powered on and receiving a signal.

• Check that the AC/DC power supply cable is connected properly and securely

to an electrical outlet. Check that the LED is showing green on the AC/DC

power supply.

• Try using another power cable.

• Try using another electrical outlet.

Is the display receiving a valid video signal from the PC?

• Check that the computer is powered on.

• Check that the video cable is connected properly and securely to the display and

the computer.

• Check that no pins are bent in the video cable connector.

• Check that the video card is firmly seated in the card slot in your computer.

• Check that the video input from the video card falls within the refresh rate of

the display. Refer to Table 1 for details.

• Check that your computer is using a supported display mode. Refer to Table 1

for details.

Is the display in Power Management mode?

• Touch the sensor, press any key on the keyboard, or move the mouse to restore

operation.

Are the brightness and contrast settings too low?

• Use the display controls to adjust these values.

Abnormal image

• Check that the video input from the video card falls within the refresh rate of

the display. Refer to Table 1 for details.

• Check that the video cable is connected properly and securely to the display and

the computer.

• Perform an Auto Config.

Colors of image

are abnormal

• Check that the video cable is connected properly and securely to the display and

the computer.

• Check that no pins are bent in the video cable connector.

Disturbances on

the sensor

• The video display adjustments are incorrect. Refer to Chapter 3 for adjusting

procedures.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35

Comments to this Manuals

No comments

3M M1700SS Specifications Page 30

Comments to this Manuals

Related products and manuals for Touch screen monitors 3M M1700SS