3M C3266PW User's Guide download pdf (Page 12)

12 3M™ Multi-Touch Chassis Display User Guide

3M Touch Systems, Inc. Proprietary Information – TSD-39373B

CHAPTER 1

Setting Up Your Multi-Touch Chassis Display

This chapter describes how to set up your 3M Touch Systems Multi-Touch Chassis

Display. You need to complete the following tasks:

• Unpack the components

• Connect the video cable, touch display cables, and power cable

• Power on the display and test your setup

• If you are not running Windows® 7 (or Tablet PC), install MT7 software from the

enclosed CD.

System Requirements

The Multi-Touch Chassis Display requires a personal computer (PC). The requirements

for your PC are as follows:

• Your PC must have an available USB or RS-232 serial communication (COM) port.

You connect the touch sensor cable to this communications port.

• Your PC must have a video card and video driver already installed for the display. If

you need to install a video card or a video driver, refer to your computer

documentation for instructions.

Note: Before setting up your Multi-Touch Chassis Display, refer to the “Important

Safety Information” section at the beginning of this document.

Unpacking Your Touch Display

Carefully unpack the carton and inspect the contents. Your Multi-Touch Chassis Display

includes the following cables and accessories:

• USB and RS-232 serial communication cables

• DVI, HDMI, and VGA video cables

• US, UK or EU power cables (as needed)

• Hardware Kit -- 4 mounting brackets and (12) 8-32 screws

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 53 54

No comments

3M C3266PW User's Guide Page 12